FAQFAQ   SearchSearch   UsergroupsUsergroups 
 ProfileProfile       

How to indentify LB from DLT tapes

 
Post new topic   Reply to topic    GEAR Software - CD / DVD Burning Software Forum Index -> GEAR PRO Mastering Edition Support
View previous topic :: View next topic  
Author Message
ws



Joined: 26 Oct 2005
Posts: 1

PostPosted: Wed Oct 26, 2005 10:47 am    Post subject: How to indentify LB from DLT tapes Reply with quote

Hello

Is this possible to identify, where is LB from ddpid file? I have two recorded tapes with DVD-9 project. I must restore project to disk and write tapes again.
Any ideas?

Regards,
ws
Back to top
View user's profile Send private message
Tom Vaughan
GEAR Guru


Joined: 12 Oct 2004
Posts: 380
Location: Contact GEAR Software

PostPosted: Fri Oct 28, 2005 3:49 pm    Post subject: Reply with quote

Yes, absolutely. The size of the layer 0 image (in sectors) is also the location of the layer break. This is because the first logical sector in layer 0 is sector 0, so the last sector in layer 0 is at a logical sector address that equals the total (count) minus 1.

It's explained further in our how-to guide...
http://www.gearsoftware.com/support/documentation/restoreddpimage.cfm
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    GEAR Software - CD / DVD Burning Software Forum Index -> GEAR PRO Mastering Edition Support All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Copyright © 2010 GEAR Software, Inc. All rights reserved. Privacy policy.